ITINERY 1. Bottles and cartridge assembly (pre-filled) 2. Main tube support 3. Small clamp 4. 10ml Syringe 5. Small needle (only required for re-
Press the yellow button and as the cartridges moves to the left unplug the mains supply from the printer. This allows the printhead to be manually
Place the bottles to the right of the printer as shown. NEVER PLACE THE BOTTLES HIGHER THAN THIS (If the bottles are placed higher then the ink may
Remove the backing tape and firmly press the small tube clamp in place as shown. Remove the backing tape from the black clamp on the tubes and fit
Fit the excess tube into the small tube clamp so it does not interfere with the printheads movements and fit the air filters into the small hole on t
Re-filling the bottles Remove the air filter and replace it with the small rubber bung (that you did not throw away). Remove the large rubber bung.
Page 7 Re-priming a system that air has been allowed to infiltrate. If ink is allowed to fall below the recommended minimum levels on the bottles it
Commentaires sur ces manuels